[. . . ] LNS-W01Z / LNS-T01Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. [. . . ] · LIGHT-BLOCK SHEET 1 pc. BE SURE TO CHECK FOR SAFETY After installing or replacing the lens, be sure to check the following for safety. Check no wiring is tangled on the gear of lens motor or the other mechanical parts. Check no part is missing, or no mounting part is loose. Some parts are not used for installation or replacement. Note : Figures in this manual may be differ from the actual product. LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps 1 to 5 for lens replacement and installation. UPPER LENS COVER C 1 REMOVE THE LENS COVER. Pull down the lower lens cover while pushing the part D, then remove it. D B 2 IN CASE OF MODEL WITHOUT LENS A D Fig-1 LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. ) Set the light-block sheet, so that the large rounder side is set over the lens. SCREWS COVER PLATE Fig-2 IN CASE OF MODEL WITH LENS REMOVE THE LENS. Remove screws D (4 screws) which fastens the lens and remove the lens. Figure shown inside of the cabinet. (D) (D) LENS MOTOR A (D) (D) B A LENS MOTOR LEAD CONNECTOR " K16B" Fig-3 3 INSTALL THE LENS. [. . . ] See figure-2. ) If the installation of light-block sheet is incorrect, it will be the cause of leakage of light or the dust entering at the main cabinet. Insert the upper part lens cover and fix them with screws A (4 screws). [. . . ]